System Travel Checklist

System Travel Checklist

When you have to travel with your All-in-One system, please use the following checklist to ensure you don't leave anything important behind.

Ensure your system package includes:
  1. All-In-One System
  2. Keyboard
  3. Ethernet Cable
  4. Wi-Fi Antenna
  5. Power Supply
  6. Training Webcam
  7. Assessment Manual
  8. Assessment Stim Cards

To prepare the system for travel, follow the below steps:
  1. Power down and unplug the unit
  2. Unscrew the Wi-Fi antenna from the top of the unit, and place in the case
  3. Place the arm that holds the computer/monitor in the travel position:
    1. Hold the top of the computer/monitor with hand.
    2. On both sides of the base of the arm, there are two silver-colored knobs. Pull both knobs out. You may need to push slightly back on the computer/monitor to release pressure on the knobs before they can be pulled out.
    3. Gently lower the computer/monitor and arm so that it is parallel to the ground.
    4. Push the silver knobs into the support holes in the monitor arm.
  4. Carefully pick up the DCAT and lower it into the case.
  5. When you reach the DCAT’s destination, reverse the above instructions to setup the unit.

    • Related Articles

    • DCAT Offline Testing

      The DCAT Online system is intended for use with an active network connection. In the case where an active or consistent network connection is unavailable, DriveABLE has included a limited Offline Testing mode, which will allow you to assess clients. ...

    • Installing a new Button Box

      Problem: The button box is no longer functional or the cleaning instructions are no longer effective, you will have to contact Impirica support for a new button box. Once you receive the new button box, you can follow the following instructions to ...

    • Button Box Cleaning Instructions

      Over time, residue may build up between the buttons and the button housings on the system.  This can cause the buttons to stick slightly in the housing when pressed down and can slow the return of the buttons to the up position when released.  Having ...

    • Changing Computer/Monitor on the Stand

      Problem: Your touch screen computer needs to be replaced and you have received a new device from Impirica. You can follow the below instructions to complete the replacement. Solution: Ensure the computer is powered down and disconnected from the wall ...

    • Device Disinfection Protocol

      To minimize the risks associated with secondary transmission of illness or infection, it is important to use disinfectant to clean the machine after each client. If the DCAT unit is not turned off, please use the Windows Shutdown option to power the ...